The TP-LINK router setting method is different in different access modes. Nowadays, the mainstream broadband access modes in China are as follows: VDS, ADSL, FTTB+LAN dynamic IP+WEB authentication, FTTB+ Static LAN + WEB authentication, broadband Internet access, etc.
A lot of access schemes use routers, but compared to different access methods, the setup method of TP-LINK routers is quite unique. This article will tell you about the details.
I. Broadband Internet access
After logging in the TP-LINK router's WEB management interface, select Ethernet Broadband through the setup wizard and automatically obtain IP from network service providers (such as China Telecom). Address (dynamic IP), after setting is complete, restart CABLEMODEM on it.
II. FTTB+LAN static IP+WEB authentication
Log in to the TP-LINK router's WEB management interface and select Ethernet Broadband through the setup wizard. Network service provider (eg: China Telecom) ) Provide a fixed IP address (static IP). After the setting is complete, then enter any URL in the IE address bar. The authentication dialog box will pop up. Fill in the username and password provided by the network service provider.
ADSL access is divided into ADSLMODEM and ADSLROUTER. If it is ADSLROUTER, it needs to be changed to RFC1483bridge and then connect TP-LINK router. Then log in to the TP-LINK router's WEB management interface, select the ADSL virtual dialing method through the setup wizard, fill in the Internet account number and Internet access password provided by the service provider, and click Next.
Fourth, FTTB+LAN dynamic IP +WEB authentication
Log in the TP-LINK router's WEB management interface, select the Ethernet broadband through the setup wizard, and automatically obtain the IP address (dynamic IP) from the network service provider (such as China Telecom).
After the setting is completed, check whether the WAN port obtains the IP address in the running state. If you get it, then enter any URL in the IE address bar. The authentication dialog box pops up and the network service provider pops up. The provided name and password are fine.
Router Settings URLs VDSL access settings are the same as for ADSL. However, in some places, you may encounter QQ, but you cannot open the webpage. You need to log in to the TP-LINK router. Under the WAN port settings in the network parameters, the value of the MTU will be reduced. The default value is 1492.
The above is the specific method for setting up the router under different broadband modes. Understanding some of the knowledge about TP-Link router settings is very important to the TP-LINK router user, and at least not bad.